lnf.cymru stimulus sheet · Design Technology · Year 7

Line-bent acrylic key fob: jumbled workshop notes and hazard cards

Please share this sheet between two and do not write on it. Use the 8 jumbled notes and the workshop hazard table below to complete your worksheet.

1. The workshop product

Year 7 pupils are making a line-bent acrylic key fob and desk stand from a rectangular blank of 3 mm cast acrylic measuring 90 mm long by 35 mm wide. The finished piece has smooth, polished edges, a 5 mm hole at one end for a metal keyring, and a neat 90-degree bend across the middle so it can also stand up on a desk to prop up a name card.

Golden rules of working with cast acrylic in the workshop:

2. The 8 jumbled, unpunctuated workshop cards (Cards A to H)

A pupil typed these 8 notes out of order and forgot to use capital letters, commas, connectives and full stops. Each card also states how many minutes that stage takes.

Card ID Raw unpunctuated note Time needed
Card A clamp the flat acrylic in the machine vice with scrap wood underneath drill the 5 mm keyring hole on the pillar drill wear goggles 4 minutes
Card B use a flat hand file to cross-file and draw-file the rough sawn edges down to the marked line keep the protective film on 6 minutes
Card C press the hot acrylic into the 90-degree wooden folding jig hold it still for 4 minutes until it cools and sets hard 4 minutes
(cooling wait)
Card D check the 90 mm by 35 mm acrylic blank use a steel rule and felt-tip pen to mark the curved corners the bend line and the hole centre on the protective film 4 minutes
Card E peel the protective plastic film off both faces of the drilled and polished acrylic blank wipe away any dust 2 minutes
Card F put on heat-resistant gloves place the bend line over the 160°C strip heater turn the acrylic every 15 seconds until the line is soft and flexible 5 minutes
Card G grip the acrylic low in the woodworker’s vice with soft jaws use a coping saw to cut neatly just outside the waste line 6 minutes
Card H wrap wet-and-dry paper around a cork block sand the filed edges with 240 grit then 600 grit with a drop of water until the edges are smooth 5 minutes

3. Workshop hazards, precautions and connectives

Use these facts in Step 2 to write complete, well-punctuated safety sentences using the connectives before, while, so that and otherwise.

Tool or machine What is the workshop hazard? What precaution prevents the hazard?
1. Pillar drill If a small piece of acrylic is held by hand, the spinning 5 mm drill bit can snag the plastic and spin it round violently, or flying swarf can hit your eyes. Clamp the flat acrylic blank tightly in a machine vice with scrap wood underneath, tie back long hair, and put on safety goggles before switching on the drill.
2. Strip heater (160°C) The guard and heated plastic reach 160°C and can burn bare fingers; leaving the acrylic still in one place causes it to blister and bubble. Wear heat-resistant gloves and turn the acrylic over every 15 seconds while heating it along the bend line.
3. Coping saw & vice Brittle cast acrylic vibrates and snaps easily if it sticks out high above the vice jaws, and metal jaws will scratch the plastic. Clamp the acrylic low down between soft wooden vice jaws so that the sheet cannot vibrate, crack or get scratched during sawing.
4. Protective film & cooling jig Leaving plastic film on over the strip heater melts the film onto the surface, and letting go of hot acrylic too early makes the 90-degree angle spring back. Peel off all protective film before heating and hold the bent acrylic in the 90-degree jig for the full 4 minutes, otherwise the film will melt or the bend will warp out of shape.