lnf.cymru stimulus sheet · Design Technology · Year 8
The Llechen phone stand, its drawing, the pupil Elin and the tablet stand tests are invented for this lesson. The data are invented. Print this sheet at actual size (100%), not “fit to page”.
Llechen is the Welsh word for a slate. The stand is made from one strip of 3 mm acrylic, 40 mm wide. The strip is heated along a line and bent in 3 places, so the stand has 4 straight parts. A phone sits on the ledge, is stopped by the lip, and leans on the back rest. The rear leg stops the stand tipping backwards.
| Part | From point to point | Real length |
|---|---|---|
| Lip | L to J | 14 mm |
| Ledge | J to K | 24 mm |
| Back rest | K to T | measure it |
| Rear leg | T to R | measure it |
The strip is drawn as a single line. Ignore its 3 mm thickness. Scale 1:2 means that every 1 mm on the drawing is 2 mm on the real stand. If your check line does not measure 50 mm, the sheet was not printed at actual size: tell your teacher.
| Title | Llechen phone stand: side view |
|---|---|
| Scale | 1:2 |
| Units | millimetres (mm) |
| Material | 3 mm acrylic strip, 40 mm wide |
| Angle | Where it is |
|---|---|
| a | At K, between the table and the back rest. This is the lean of the back rest. |
| b | At K, inside the bend, between the ledge and the back rest. |
| c | At T, between the back rest and the rear leg. |
| d | At R, between the rear leg and the table. |
| e | At J, between the ledge and the lip. |
Using a protractor. Estimate first: is the angle acute (less than 90°) or obtuse (between 90° and 180°)? Put the centre cross exactly on the corner. Line up the zero line with one arm of the angle. Find the 0 that sits on that arm and count up from it, using that scale only (inner or outer). If an arm is too short to reach the numbers, extend it lightly with a pencil and ruler.
Elin, a Year 8 pupil, copied the stand at scale 1:2 before she cut her strip. She wrote down what she drew.
| Part or angle | What Elin drew |
|---|---|
| Lip | 7 mm |
| Ledge | 12 mm |
| Back rest | 120 mm |
| Angle a (the lean) | 115° |
| Rear leg | straight down to the table, at 90° |
Her teacher said: “Two of these are wrong. Part of your drawing is not at 1:2, and your phone could not lean on that back rest.”
The class want a bigger version for a tablet, for reading recipes on a kitchen worktop. It has the same shape, with a back rest 180 mm long. They made card models with different lean angles (angle a). Each model was tapped on the screen 10 times, and 10 testers said whether it was comfortable to read.
| Lean angle a | Taps that tipped it over (out of 10) | Testers who found it comfortable (out of 10) |
|---|---|---|
| 55° | 0 | 6 |
| 60° | 0 | 9 |
| 65° | 1 | 9 |
| 70° | 3 | 8 |
| 75° | 6 | 5 |
Specification: the tablet stand must tip over 0 times in 10 taps, and at least 8 out of 10 testers must find it comfortable.