Cover lesson · Drama · Year 8 · Intermediate

Timing scenes and cues for a show

LNF: Numeracy → Learning about geometry helps us understand shape, space and position, and learning about measurement helps us quantify in the real world → Measurement

Name: Class: Date:

Cover teacher: you need no subject knowledge

What this practises: timing events in minutes and seconds, converting between seconds and minutes, finding a mean time, and planning an evening on a 24-hour timeline, as a stage manager does. Pupils plan an invented school show, Harbour Lights, at the invented Ysgol Aberheli. This is Key Stage 3 groundwork for GCSE Drama (WJEC, Made for Wales), where devised and scripted performances in Units 1 and 2 must fit set time limits and designers write cue sheets.

Print: this sheet, one per pupil, and the stimulus sheet “Harbour Lights: running order, rehearsal timings and cue sheet”, one between two. Calculators are allowed. For Step 1 each pair needs a way to time 30 seconds: the classroom clock’s second hand, a watch, or a stopwatch. If school rules allow, a phone stopwatch in flight mode is fine for Step 1 only. No computers are needed.

Run: 8 min Step 1, the 30-second freeze-frame in pairs · 6 min Step 2, seconds and minutes · 7 min Step 3, adding up the acts · 6 min Step 4, the mean run-through · 8 min Step 5, the evening timeline · 7 min Step 6, cue times · 8 min Step 7, what to cut. Total 50 minutes. Step 1 is a little noisy for 2 minutes; after that the lesson is written work in pairs.

Collect: this sheet.

Quick checks: Step 2: 95 s = 1 min 35 s; 1.5 minutes = 1 min 30 s, not 1 min 50 s. Step 3: Act 1 = 27:55, Act 2 = 23:35. Step 4: mean Act 1 = 28:20, mean Act 2 = 24:55. Step 5: Act 2 ends at 20:17:15, which is 2 min 15 s after 20:15. Step 6: LX 3 = 7:10 into Act 1; SQ 4 = 2:55 into Scene 2; LX 5 = 16:05; SQ 8 = 27:47. Step 7: cutting only Scene 3, only Scene 5, or only shortening the interval to 15 minutes each ends just after 20:12. Accept any plan that ends by 20:12 without cutting Scenes 1, 2, 4, 7 or 8, if the working is shown. The worked example has every answer.

What you are doing

You are the stage managers for Harbour Lights, the Year 8 show at Ysgol Aberheli. The rehearsals are running too long. You will practise timing in seconds, add up the scenes, find the mean of three run-throughs, plan the evening on the 24-hour clock, work out when each cue happens, and decide what to cut so the show ends on time.

Key words:

Step 1: the 30-second freeze-frame

Work in pairs. One of you is the performer and one is the timer.

PerformerAttemptReal time (seconds)Error (seconds)
1
2
1
2

(a) Put the 4 real times in order from the most accurate (smallest error) to the least accurate.

(b) Which unit would you use to time each of these: a sound cue, a scene, the whole evening? Why?

Step 2: seconds and minutes

QuestionAnswer
(a) SQ 1, the thunder, lasts 95 seconds. Write this in minutes and seconds.
(b) SQ 4, the seagulls, lasts 2 minutes 20 seconds. How many seconds is that?
(c) SQ 2 is 3 foghorn blasts of 6 seconds, with 4 seconds of silence between blasts. How long is the whole cue in seconds?
(d) Scene 4 lasts 8:40. How many seconds is that?
(e) Write 1675 seconds in minutes and seconds.
(f) A pupil wrote 1.5 minutes as “1 minute 50 seconds”. Correct it and explain the mistake.

Step 3: adding up the acts

Use the running order. Add the minutes and the seconds separately, then change every 60 seconds into 1 minute.

Total of the scene lengthsScene changes (3 × 45 seconds)Length of the act
Act 1 (Scenes 1 to 4)
Act 2 (Scenes 5 to 8)

Check: compare your two act lengths with Run 3 in the rehearsal timings. What do you notice?

Step 4: the mean run-through

(a) Find the mean length of Act 1 over the three run-throughs. Tip: change each time into seconds first, add, divide by 3, then change back.

(b) Find the mean length of Act 2 in the same way.

(c) The show got faster at every run-through. Is the mean a sensible time to plan with? Give one reason why the real show might take longer.

Step 5: the evening timeline

Use the hall booking and your mean times from Step 4. Give each time to the second on the 24-hour clock.

EventTime
Welcome from Mrs Pritchard starts19:00:00
Act 1 starts
Act 1 ends and the interval starts
Act 2 starts
Act 2 ends, after the bows

(a) Does the show finish by 20:15? By how much is it early or late?

(b) How long is it from doors opening at 18:30 to the end of the bows? Give your answer in hours, minutes and seconds.

Step 6: cue times

First work out when each scene in Act 1 starts, using the Run 3 lengths and the 45-second scene changes. Scene 1 starts at 0:00.

Scene1234
Starts at (time into Act 1)0:00

Now fill in the missing time for each cue. Time from the start of the scene = time into Act 1 − time the scene starts.

CueSceneTime into Act 1Time from the start of the scene
SQ 213:40
LX 320:20
SQ 429:45
LX 531:10
SQ 6421:30
LX 7425:48
SQ 84

At what time into Act 1 do the seagulls (SQ 4) stop?

Step 7: what to cut

Read the director’s notes. The bows must now finish by 20:12. Start from your end time in Step 5. Cutting a scene saves its Run 3 length plus one scene change of 45 seconds.

OptionTime savedNew end timeFinished by 20:12? (yes or no)
A: cut Scene 3
B: cut Scene 5
C: cut Scene 6
D: cut no scene, make the interval 15 minutes

Your plan for Mr Morgan. You may combine options, or cut a scene and shorten the interval. Give your new end time, show that it is no later than 20:12, and explain in 2 or 3 sentences why your plan is fair to the cast and the audience.

Step by step

  1. 8 min Step 1: time the 30-second freeze-frame in pairs, work out the errors and order them.
  2. 6 min Step 2: convert between seconds and minutes.
  3. 7 min Step 3: add up the scenes and scene changes in each act.
  4. 6 min Step 4: find the mean length of each act.
  5. 8 min Step 5: plan the evening on the 24-hour clock.
  6. 7 min Step 6: work out the scene start times and the cue times.
  7. 8 min Step 7: test the options and write your plan.

Success criteria

If you finish early